Beogram to non-B&O device (Phono Pre-amp / Receiver / Amplifier etc)
Connect your B&O BeoGram turntable to your non-B&O audio system or a phono pre-amplifier using stereo RCA/ Twin phono sockets.
Shop with confidence at Sounds Heavenly. Pay safely by credit / debit card, or with PayPal in our secure site.
We offer Free UK shipping, plus Worldwide shipping for a small extra cost. Tracked delivery is also available as an option.
Your local postal service may also charge Customs fees on delivery if you are outside UK (these fees are not included in the purchase price). Please contact us if you have any questions.
Beogram Turntable to Non-B&O device
Use your Beogram with a Phono Pre-Amp/ Amplifier
This high quality converter cable will allow you to connect a B&O Beogram Turntable into your non-B&O audio systems or phono pre-amplifiers using stereo RCA/ Twin phono sockets. These turntables come with a standard B&O 5 or 7 pin DIN plug on a fitted cable.
Please note that some Beogram turntables have built-in pre-amplifiers and so these should be connected to a line level input on your amplifier - if you are in any doubt, please ask!
As Beogram turntables are earthed via the audio ground, no external earth wire is needed. This cable contains internal grounding links as standard to prevent spurious noise caused by earthing issues and this is suitable for most amplifiers. However, if your amplifier has a separate grounding point which requires an external ground wire, please select this option.
This cable uses premium quality, gold-plated RCA plugs and will fit almost all audio systems and phono pre-amplifiers with RCA input sockets.
- Twin Screened Pure-Crystal Oxygen-Free Copper cable with Sounds Heavenly signature Blue sheath
- Signal conductors (x 2): 7 x 0.2mm PC-OFC copper
- Screening conductors (x 2): 16 x 0.12mm PC-OFC copper
- Deltron metal-bodied 7-pin female DIN socket
- Twin 24 carat Gold-Plated metal-bodied RCA plugs
- Internal ground link within DIN plug or optional external ground wire
If you have a Beogram 8000 or 8002 turntable with a DIN socket on the rear panel (instead of the usual fitted lead and DIN plug), please note that this cable WILL NOT FIT unless you have the original B&O double-shielded male 7 pin DIN cable that was supplied with the turntable.