Beogram to non-B&O device as used on Beogram 4000c (Phono Pre-amp / Receiver / Amplifier etc) B&O ref: 6271348

Beogram Turntable to Non-B&O device

Use your Beogram with a Phono Pre-Amp/ Amplifier - This cable is also supplied from our workshop to Bang & Olufsen to be included with their Beogram 4000c turntables (B&O Stock Code: 6271348).

This high quality converter cable will allow you to connect a B&O Beogram Turntable into your non-B&O audio systems or phono pre-amplifiers using stereo RCA/ Twin phono sockets. These turntables come with a standard B&O 5 or 7 pin DIN plug on a fitted cable.

Please note that some Beogram turntables have built-in pre-amplifiers and so these should be connected to a line level input on your amplifier - if you are in any doubt, please ask!

As Beogram turntables are earthed via the audio ground, no external earth wire is needed. This cable contains internal grounding links as standard to prevent spurious noise caused by earthing issues and this is suitable for all pre-amplifiers.

This cable uses premium quality, gold-plated RCA plugs and will fit almost all audio systems and phono pre-amplifiers with RCA input sockets.

• Twin Screened Pure-Crystal Oxygen-Free Copper cable with Sounds Heavenly signature Blue sheath
• Signal conductors (x 2): 7 x 0.2mm PC-OFC copper
• Screening conductors (x 2): 16 x 0.12mm PC-OFC copper
• Deltron metal-bodied 7-pin female DIN socket
• Twin 24 carat Gold-Plated metal-bodied RCA plugs
• Internal ground link within DIN plug

If you have a Beogram 8000 or 8002 turntable with a DIN socket on the rear panel (instead of the usual fitted lead and DIN plug), please note that this cable WILL NOT FIT unless you have the original B&O double-shielded male 7 pin DIN cable that was supplied with the turntable.